8965 One component PU Polyurethane Windshield Adhesive , automotive glass bonding sealant adhesive

How to use
Cleaning: Clean the surface to be bonded,remove rust, dust, water and oil. Glue: Cut a suitable small hole on the tip of the glue barrel, the inner diameter of the mouth of the
glue nozzle should be determined by the glue application width, put it into the glue gun and start
the glue application operation. Primer:It needs to be used with Huitian designated activator and primer. The time for the primer
to wait for volatilization and drying is usually 10-30 minutes. The specific time depends on the
ambient temperature at that time. After the primer is volatilized and dried, the glue is applied. Cure: The temperature and humidity of the environment have a great influence on the surface
drying and curing of the polyurethane adhesive. If the temperature is too low, the curing will be
slower; if the temperature and humidity are too high, the surface drying will be faster. The best operating environment conditions are: temperature 20～30℃, humidity 50～70%RH;please operate with caution beyond the range of temperature 5～35℃ and humidity 35～75%RH. During the sizing and curing process of polyurethane adhesive, avoid contact with chemicals
containing hydroxyl and amino groups, which will cause the polyurethane adhesive to not cure or
cure incompletely. Storage:Unused glue should immediately tighten the cap and seal the nozzle for storage. When
using it again, if there is a little crust on the seal, it can be removed without affecting normal use. During storage, there may be a small amount of crust on the mouth of the nozzle, which can be
used normally after removal without affecting the performance of the product.

8965 One component pu sealant adhesive was well accepted by many OEM , High performance and fast positioning !